Installing The Belt Clip; Resetting Handsets - Uniden TWX977 Owner's Manual

Notes:
• If there is any foreign matter on the rubber seal located on
the under side of the battery cover, the handset may not be
water resistant.
• The rubber seal should be kept clean and replaced every 2
years to ensure the handset is water resistant even if the
seal does not look worn.
• Do not place an excessively dirty handset in the base.
• Shake excess water from handset prior to placing back in
the charging cradle.

Installing the Belt Clip

Line up the tabs with the holes on each
side of the handset. Press the belt clip
down until both tabs click into place.
To remove the belt clip, pull both sides of
the clip to release the tabs from the holes.

Resetting Handsets

If you want to register the handset to a different base or
replace a handset with another one, you must first clear the
registration information from the base and the handset.
1. Press and hold
at least 5 seconds, until the
SYSTEM RESET menu
appears.
2. Select the DEREGISTER HS
submenu. WHICH HANDSET?
appears in the display.
3. Move the cursor to select the handset ID to be de-registered
from the list, and then press the OK soft key. DEREGISTER HS
appears.
4. Move the cursor to select YES, and then press the OK soft key.
When ARE YOU SURE? appears, select YES. You will hear a
confirmation tone.
[ ] [#]
and for
8