Private Bank Scanning
Programming Frequencies into Channels
Before the scanner begins Private Bank scanning, you must program a frequency into at
least one channel.
Visit our website (www.uniden.com.au, www.uniden.co.nz) for
information on known frequencies.
You will need to program each frequency into the scanner's channels in order to hear these
frequencies.
1. Press
HOLD/RESUME
number where you want to store a frequency by
using the keypad, then press
.
Change the channel by using the
2. Enter the frequency you want to store by using the
keypad and
(decimal key).
3. Press
E
to store the frequency into the channel.
4. If you want to program another frequencies into the
channel, select another channel by using the
key.
Note:
•
To clear a mistake while entering the frequency, press
repeatedly until the display is cleared.
• If you enter a invalid frequency, an error tone will sound and
the display. To clear the Error message immediately, press
• Even if you don't enter full numbers as a frequency number, the scanner will
automatically select the nearest valid frequency.
Deleting a Stored Frequency
To delete a stored frequency:
a. Select a channel.
b. Press .
0
c. Then press .
E
Note:
Channels with no frequencies are automatically locked out.
and enter the channel
HOLD/RESUME.
or
key.
or
SCAN
SCAN
SCAN
(decimal key)
"Error"
appears on
(decimal key).