Search Frequency Skip; Programming With Search - Uniden UBC 220XLT Operating Manual

Search Frequency
Skip.
The scanner may stop at certain frequencies during Search
that you do not want to hear. You can program up to 10 Skip
Frequencies into the UBC 220XL T. When the scanner stops at
one of these frequencies during Search, press @[)
.
That
frequency is now "memorised" and will be skipped during any
Search. The scanner will then search to find other active
frequencies.
Caution:
If you attempt to lock out more than 10
frequencies, you will overwrite those frequencies
already stored in the Search Skip Memory.
i
I
To remove UO from skipped frequencies, put search on HOLD
then press @J for at least two seconds. You will hear two beeps
and all skipped frequencies are returned to the search cycle once
resumed.
Programming With SEARCH
The Search feature enables you to rapidly search for active
frequencies within band limits you specify. When an
interesting frequency is found, you can store it in a channel
using the procedure below.
1. press@.
2. Use the key pad to select the channel you wish to store
a frequency in.
3. Press
~
to access that channel.
I
4.
Use the keypad to enter the lowest frequency of the
band you wish to search.
Press ~IMI"9.
5.
6.
Enter the highest frequency of the band you wish to search.
7.
Press ~IMI"9.
8. Press ISRCHI.
9. The channel you chose above will be blinking on the display.
10. When Search stops on a desired frequency, press (1I0OI)
to stay on that frequency.
BANK 2
~iY~BD6.DDDD
DATA/I,
SRCH HOLD DLY
11. To store the displayed frequency in that channel, press
CD
.
The channel number on the display stops blinking.
Repeat this procedure to store other frequencies found in
SEARCH Mode.
21