Registering The Search Frequency In Channel Memory - Uniden UBC30XLT Owner's Manual

UB333 Paper OM reduced size.fm Page 26 Friday, June 3, 2005 1:43 PM
3. Press PWR or wait for 2 seconds to return to the
mode you were in.
You can search for Air, FM Radio and VHF High
band without knowing the specific frequencies used
in your area. Press
direction.
When the scanner stops on a transmission, press
RSM/HOLD to stop searching and listen to the
transmission. HOLD appears. In this mode, you can
press or to increment or decrement the
frequency by 1 step. Press and hold
increment or decrement frequency continuously.
To release the hold and continue searching, press
RSM/HOLD.
Registering the Search Frequency
In Channel Memory
You can store frequencies you found during
Frequency Search Mode or Frequency Hold Mode
into channels.
1. Press FNC + MW. A blank channel and the
frequency you found are displayed alternately.
2. Repeatedly press
where you wants to register.
3. Press FNC + MW to complete the registration.
Registered channel frequency is distributed to
each bank according to the a frequency band.
If you entered a frequency that has already been
entered elsewhere, the scanner sounds an error
tone and displays the channel that was duplicated.
If you entered the frequency by mistake, press PWR
then enter the correct frequency. To enter the
frequency anyway, press FNC + MW to accept.
or to change the search
or
or to select the channel
Operation
26
to