Uniden SC180 Operating Manual page 12

8. Press
you program frequency or Alpha characters. Press and
hold
Manual mode.
9. Use
programming a frequency into a channel. If you
make an entry error, press
key to erase the entry, and start over. Also, use
/ CLR to clear the error message display.
10. Press
characters into any displayed channel.
11. Press
displayed channel, including Priority Channels. (L/O
appears on the display.) To unlock a channel, press
again.
Modes.
12. There are 10 Preprogrammed NOAA weather
channels. Press
weather channel in your area. WX appears on the
display in Weather Mode. If you want to set or reset
the Attenuator function, press and hold
13. Press
delay during scanning or searching for active
frequencies. (When delay is activated, DELAY appears
on the display.) In this mode, when the scanner
monitors an active frequency, searching or scanning will
not resume until transmission stops for 2 seconds.
14. While Scanning, press
PRIORITY SCAN function. (PRIORITY appears on the
display.) While Searching, press
toggle between 100 steps and 300 steps per second.
(When in TURBO SEARCH is activated. SEARCH
flashes on the display.)
15. Press and hold
display. This disables the keypad and VFO control
and prevents any accidental key entries. To enable
the keypad, press and hold
disappears from the display.
16. Press
Press and hold
scanner turn the LCD Back Light on when a
transmission is found (Auto Light function).
/ ALERT to change the display mode when
/ ALERT to set the Alert Beep function in
/ CLR to enter the decimal point when
to store a displayed frequency and Alpha
to "Lock Out" or prevent scanning of the
can be used in Scan or SEARCH
to turn ON or OFF the automatic 2-second
to turn the LCD Back light on and off.
for 2 seconds to make the
/ CLR before the
/ ATT to find the active NOAA
/ TURBO to activate the
until appears on the
9
/ ATT .
/ TURBO to
until