Step2: Programming Trunking Frequencies - Uniden BC250D Owner's Manual

71 for instructions.
STEP 1 is complete.
No. LCD display
1 Type 2 800
2 Type 1
3 Type 2 900
4 Type 2 UHF
5 Type 2 VHF
6 EDCS WIDE
7 EDCS NARROW
8 EDCS SCT.
9 LT
Note: Information on APCO P-25 Systems are referred to in
"APCO Project 25 Reception" on page 76.
STEP 2:
Programming Trunking Frequencies
After you finish selecting the bank and trunk type you want to
track, store the frequencies in the channels for your selected
bank in your scanner. Remember that you can only store one
trunking system in each bank.
Important: If you are programming an EDACS or LTR
trunked system, you must enter the frequencies
in a specific order. Check the frequency guide
included with the scanner for the frequencies in
your area. For additional frequencies, check the
web sites listed on page 11.
1. Press MENU/BACK.
2. Select 2:SCAN OPTION /
2:TRUNK by rotating the VFO and
pressing E.
3. Select the bank number by rotating the
VFO and pressing E.
4. Select 2:TRUNK CHANNEL and
enter the channel number by rotating the VFO and
pressing E.
5. Select 1:FREQUENCY and enter a frequency for the
trunked system using the keypad and pressing E.
6. Enter the alpha tag and press E. (See page 53).
7 You can also change the step size in this menu.(See page
103)
Note: • To clear a mistake while entering the frequency,
Icon TrunkingType
M Motorola Type 2 800 MHz
M Motorola Type 1
M Motorola Type 2 900 MHz
M Motorola Type 2 UHF
M Motorola Type 2 VHF
E EDACS Wideband 9600 baud
E EDACS Narrowband 4800 baud
E EDACS SCAT
L LTR
Special requirements
a. Must program a fleet map.
b. Must program base, spacing,
frequency and offset channel.
c. Must program frequencies
in exact order and location.
50
CH/
FRQ
HOLD/
RSM
MAN
SCAN SERVICE SEARCH
MENU/BACK TRUNK
L/O
REVERSE SELECT
.
E