Before You Start; Installation - ABB ACS800 Series Hardware Manual

44
Screws are not included in the installation kit. The following screws are needed:
• frame size R5:
18 pieces: M5X12, torque 3 N·m (2.2 lbf·ft)
2 pieces: M4X16, torque 1.2 N·m (0.9 lbf·ft)
2 pieces: M4X12, torque 1.2 N·m (0.9 lbf·ft)
• frame size R6:
20 pieces: M5X12, torque 3 N·m (2.2 lbf·ft)
2 pieces: M4X25, torque 1.2 N·m (0.9 lbf·ft)
2 pieces: M4X12, torque 1.2 N·m (0.9 lbf·ft)

Before you start

Prepare the cabinet by following the requirements given in this manual and the
dimensional drawings on pages
The drive must always be fixed into the cabinet by using the original 4 fixing holes on
the bottom plate, never by the collars only.
The cabinet supports (E) can be installed before or after installing the drive, but it
may be easier to install the drive before the supports.

Installation

The following figure shows the installation procedure for a drive of frame size R5. In
frame size R6, the design of the bottom collar (D) is slightly different.
1. After the drive and cabinet supports (E) have been installed, install the left (A) and
right collars (B) by pushing them first in the grooves on both sides of the drive,
and fasten them with 10 pcs of M5x12 screws (frame size R6: 12 pcs) in the
cabinet supports.
2. Fix 4 pcs of M5x12 screws in the left (A) and right collars (B), and install the top
collar (C) against the left and right collars through the screws.
3. Push down the top collar in the groove on the top of the drive and tighten the
screws.
4. Fix 4 pcs of M5x12 screws in the left (A) and right collars (B), and install the
bottom collar (D) against the left and right collars through the screws.
5. Push up the bottom collar in the groove on the bottom of the drive and tighten the
screws.
6. Fix the bottom collar to the drive with 2 pcs of M4x16 screws (frame size R6:
M4x25).
7. Secure the bottom collar to the drive with additional 2 pcs of M4x12 screws.
Note: If you install other parts in the cabinet, make sure that the top and bottom
collars can be removed easily for maintenance purposes.
Mechanical installation
134 and 135.