Installing The Cisco Microsoft Windows Usb Device Driver - Cisco 1100 Series Hardware Installation Manual

Installing and Connecting the Router
Example:
root@usb-suse /dev# screen /dev/ttyACM0 9600
To disconnect the Linux USB console from the Terminal window
Enter Ctrl-a followed by : then quit

Installing the Cisco Microsoft Windows USB Device Driver

A USB device driver must be installed the first time a Microsoft Windows-based PC is connected to the USB
serial port on the router.
This section contains the following topics:
Installing the Cisco Microsoft Windows XP USB Driver
This procedure shows how to install the Microsoft Windows XP USB driver.
Before you begin, download the appropriate driver for your router model from the Cisco Software Download
site, USB Console Software category:
Step 1 Unzip the file Cisco_usbconsole_driver_X_X.zip (where X is a revision number).
Step 2 If using 32-bit Windows XP double-click the file setup.exe from the Windows_32 folder, or if using 64-bit Windows
XP double-click the file setup(x64).exe from the Windows_64 folder.
Step 3 The Cisco Virtual Com InstallShield Wizard begins. Click Next.
Step 4 The Ready to Install the Program window appears, Click Install.
Step 5
The InstallShield Wizard Completed window appears. Click Finish.
Step 6 Connect the USB cable to the PC and router USB console. The LED of the USB console port turns green, and within a
few moments the Found New Hardware Wizard appears. Follow the instructions to complete the installation of the driver.
Step 7 The USB console is now ready for use.
Installing the Cisco Microsoft Windows USB Device Driver
http://www.cisco.com/cisco/software/navigator.html
Hardware Installation Guide for the Cisco 1100 Series Integrated Services Router
35