Tone Dialing Switch-Over - Uniden TRU3466 Owner's Manual

note
Only the last number
dialed can be accessed
after the selected line
key has been pressed.
note
The tone feature only
applies when the dial
mode is set to pulse.
[ 16 ] B A S I C S
R R e e d d i i a a l l f f r r o o m m T T a a l l k k M M o o d d e e
1) Press line1.
2) Press redial/pause.
The last number dialed will be displayed and redialed.
3) To hang up, press the select line key or place the handset on the base. The
call-time will be displayed for about 5 seconds.
F F r r o o m m t t h h e e B B a a s s e e
1) To call the last number dialed from the base, press line 1.
2) Press redial/pause. The last number dialed from the base is redialed.
3) To hang up, press the selected line key.

Tone Dialing Switch-over

Some telephone companies use equipment that require pulse
dialing (sometimes referred to as rotar y dialing). If you
need to enter tone dialing digits, you can switch-over to tone
dialing during the call. An example of this could be entering your bank account
number after you have called your bank. The digits of your bank account can be
entered using DTMF tones.
Initially make your call with the pulse dialing mode. Once your call connects,
press / /tone for the handset, or
t t
*
(like in example above the bank account number). These digits will be sent as
tone dialing. This special number can be stored in a memor y location. This is
referred to as Chain Dialing (See page 31). Once the call ends, the tone mode
is canceled and pulse dialing mode resumes.
/tone for the base. Enter the desired number
*