Changing.the.line.mode.for.multiple.extensions; Traveling.out.of.range - Uniden DECT2085 Series Owner's Manual

Changing the Line Mode for Multiple Extensions
Line.mode.refers.to.the.method.that.telephones.use.to.signal.each.other.that.an.extension.is.in.use..Customer.
service.may.recommend.changing.the.line.mode.if.you.have.any.of.the.following.problems:
• Your.phone.keeps.ringing.after.someone.answers.on.an.extension.phone.
• Your.answering.system.doesn't.stop.recording.when.you.answer.on.an.extension.phone.
Caller ID displays briefly and then clears.
•
) If.you.set.from.a.handset.and.you.have.multiple.bases,.select.the.base.that.is.having.problems.(see.page.25).
2) Press.[Menu/Select]..Select.the.GLOBAL.SETUP.menu,.and.then.the.SET.LINE.MODE.submenu..
3) IF.INSTRUCTED.BY.CUSTOMER.SERVICE.PRESS.[SELECT].appears..Press.[Menu/Select].
4) Move.the.cursor.to.select.TYPE.-.A,.TYPE.-.B,.or.OFF.
Press.[Menu/Select]. You will hear a confirmation tone.
5)
Traveling Out of Range
During.a.call,.if.you.move.your.handset.too.far.from.your.base,.noise.may.increase..If.you.pass.the.range.limit.of.the.
base,.the.handset.will.beep,.display.OUT.OF.RANGE,.and.then.go.to.standby..The.base.will.maintain.the.connection.
for.thirty.seconds.after.the.handset.goes.out.of.range..If.you.move.the.handset.back.within.range.of.the.base.within.
thirty.seconds,.press.[ /Flash].or.[
Note:. If.it.is.set.to.automatically.select.the.available.base,.the.handset.will.begin.searching.for.another.base.thirty.
seconds.after.going.out.of.range..(see.Selecting.the.Base.on.page.25).
].to.pick.up.the.call.again.
59