Using Your Phone; Make A Call; Adjust The Earpiece/Speaker Volume During A Call; Make A Call By Pre-Dialing - Uniden DECT1060 Owner's Manual

Using your phone

Make a call

1 Press the
you hear the dial tone, dial the number you
want. The number is shown in the display.
After a short delay the call timer will start timing
the call.
2 Press to exit and return to standby.
Adjust the earpiece/speaker volume during a
call
1 Press or to adjust the volume.
There are six levels.

Make a call by pre-dialing

1 In standby, enter the number to be dialed.
The number is displayed.
You can enter numbers up to 24 digits long.
Press to delete any incorrect digits.
Press and hold
2 Press to dial the displayed number.
symbol is displayed. When
to delete all digits.

Handset range

If the handset is too far away from the base,
during standby,
symbol will flash. During a call you will hear a
warning tone. You will need to mover closer to the
base for clearer reception and to avoid being
disconnected.

Call timer

When you make or receive a call, a short while
after the line is connected the call timer will show
the duration of the call in the display in hours,
minutes and seconds. The call time will be
displayed for a further 5 seconds after you end
the call.

Handsfree

You can use handsfree to talk to your caller
without holding the handset to your ear. You can
speak into the handset microphone and listen over
the loudspeaker.
Handsfree also enables other people in the room
to listen in to the conversation.
[12]
appears and the