Additional Information; Changing The Digital Security Code; Installing The Beltclip; Headset Installation - Uniden DCT5260 Owner's Manual

Changing the Digital Security Code

The digital security code is an identification code used to connect the handset and the
base unit. Normally, setting the code is not necessary. In the rare situation that you
suspect another cordless telephone is using the same security code, you can change the
code. To change the digital security code:
1. Perform the "System Reset" menu options ("De-register the Handset" and
"Replacing the Base Setting") for all the handsets you have (see page 25).
2. To register all the handsets do the following steps:
1) Place a handset, one at a time in the base.
2) Registration starts automatically.
While registering "
3) When the registration is complete, "
4) Repeat steps 1 - 3 for another handsets.
If the registration fails, "
above again.

Installing the Beltclip

To attach the beltclip
Insert the beltclip into the holes on each side of the handset.
Press down until it clicks.
To remove the beltclip
Pull both sides of the beltclip to release the tabs from the holes.

Headset Installation

Your phone may be used with an optional headset, the Uniden
HS910. To use this feature, insert the headset plug into the
headset jack. Your phone is ready for hands-free conversations.
(Headset may be purchased by calling the Uniden Parts Department
or visiting the web site. See page 11.)
" appears in the display.
" appears in the display.
" appears in the display. Try the steps
A D D I T I O N A L I N F O R M A T I O N [ 51 ]