Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Figure 6. Disconnect the EDP cable from the LCD module and remove the LCD module
Go to
https://support.lenovo.com/partslookup
part:
LCD module
Remove the EDP cable
Make sure the following FRU (CRU) has been removed.
"Remove the LCD module" on page 26
Step 1.
Peel off the tape. Disconnect the EDP cable from the system board and then remove the EDP
cable.
Figure 7. Remove the EDP cable
Go to
https://support.lenovo.com/partslookup
part:
EDP cable
Remove the battery pack
Make sure the following FRU (or CRU) has been removed.
28
Hardware Maintenance Manual
to look up the Lenovo part number of the following replacement
to look up the Lenovo part number of the following replacement