Uniden CEZAI 998 Series Owner's Manual page 61

Symptom
Messages are incomplete.
After a power failure, the
outgoing message is
deleted.
No sound on the base
speaker during call
monitoring or message
playback.
Cannot access remote call-
in features from another
touch tone phone.
CID Announce feature is
not announcing new
incoming calls.
w w w . u n i d e n . c o m
• The incoming messages may be too long. Remind callers to leave a brief
message.
•The memory may be full. Delete some or all of the saved messages.
• Record your personal outgoing message again. The default message should
remain.
• Adjust the speaker volume on the base.
• Make sure the call screen feature is set to on.
• Make sure you are using the correct PIN code.
• Make sure that the touch-tone phone you're using can transmit the tone for at
least two seconds. If it cannot, you may have to use another phone to access
your phone.
• Check to make sure the CID Announce switch on the back of the base is set to
ON.
• Check your base speaker volume to ensure it is loud enough to hear the CID
Announce feature.
Suggestion
T R O U B L E S H O O T I N G [ 6 0 ]