Uniden UDWC23 User Manual page 6

Mounting Mounting
Camera Camera
screw screw
brace brace
Mounting Mounting
post post
Post Post
lock lock

1. Hold the base of the mount where you want
to attach it, and mark the location of the
screw holes.
2. Use the included screws and anchors to
attach the base to the wall or ceiling.
3. Attach the camera to the mounting screw.
Tighten it a few turns, then turn it to the
direction you want.
4. Tighten the camera brace up against the back
of the camera to secure it into place.
Screw Screw
holes holes
5. Unlock the mounting post by turning the
wingnut to the left a few turns.
. Set the mounting post to the correct angle,
then tighten the wingnut until the post is
locked into place.
Tighten the brace against Tighten the brace against
2 2
the camera to the camera to
secure it secure it
in place. in place.
3 3
Loosen the Loosen the
wingnut to wingnut to
unlock the unlock the
mounting mounting
post. post.
Attach the camera Attach the camera
1 1
to the mounting to the mounting
screw and turn it screw and turn it
to the desired to the desired
direction. direction.
Adjust the post to Adjust the post to
4 4
the correct angle, the correct angle,
then tighten the then tighten the
wingnut to lock the wingnut to lock the
post into place. post into place.