Connecting The Telephone Cords; Applying Power To The Base Unit - Uniden XCA4500 Instruction Manual

Connecting the Telephone Cords

Consider these safety guidelines before connecting the telephone cords:
CAUTION:
Never install telephone wiring during a lightning storm.
Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected.
Use caution when installing or modifying telephone lines.

Applying Power to the Base Unit

The XCA4500
switch to interrupt power) and the included AC adapter. Connect the adapter
as shown below.
1. Wrap the power cord around
the convenient notch on the
bottom.
Important:
cord so that it does not create
a trip hazard, or where it
could become chafed and
create a fire or other electrical
hazards.
2. When power is first applied,
the Message Counter LED
display flashes
while the system's memory
initializes. When the flashing
slows, press the
on the Base Unit.
3. The Message Counter LED
display turns off, and the time
and remaining message
record time are announced.
Note: For information about
turning the Answering
System On/Off, see page 46.
requires a standard electrical outlet (120 volts AC without a
Place the power
P
quickly
STOP button
NEW MESSAGE
STOP
DELETE
NEW MESSAGE
STOP
DELETE
10
P
REPEAT PLAY SKIP
ANS ON/OFF OGM MEMO INTERCOM
PAGE/FIND
REPEAT PLAY
ANS ON/OFF OGM MEMO
PAGE/FIND
SKIP
INTERCOM