Beacon Light Switch - Toro ProLine H800 Service Manual

Beacon Light Switch

g294707
1. Beacon light switch
Testing the Beacon Light Switch
Electrical System: Testing the Electrical Components
The beacon light switch is located on the dash panel
The beacon light switch controls the operation of the beacon light.
g294694
1. Park the machine on a level surface, lower the cutting deck, set the parking
brake, and shut off the engine.
2. Disconnect the battery negative (-) cable at the battery.
3. Remove the dash panel and get access to rear of the beacon light switch;
refer to Disassembling the Body Assembly (page
4. Disconnect the wire harness connector from the beacon light switch and
remove the beacon light switch from the dash panel.
Figure 117
Figure 118
Page 6–20
(Figure 117).
7–6).
ProLine H800
19241SL Rev A