Toro ProLine H800 Service Manual page 269

Removing the Operator Seat
Installing the Operator Seat
ProLine H800
19241SL Rev A
g289938
1. Operator seat
2. Seat switch wire harness
1. Park the machine on a level surface, set the parking brake, lower the cutting
deck, shut off the engine, and remove the key from the key switch.
2. Disconnect the battery negative cable from the battery; refer to Operator's
Manual.
3. Disconnect the seat electrical connector from the machine wire harness
(Figure 149).
4. Slide the operator seat (2) to forward; refer to Operator's Manual.
5. Remove the 4 socket head screws (5), washers (10) and nut (11) that
secures the operator seat (2) to the seat support (9).
Make sure to not damage the electrical harness while removing the
operator seat.
6. Lift and remove the operator seat (2) from the seat support (9).
Make sure to not damage the electrical harness while installing the
operator seat.
1. Carefully position the operator seat (2) onto the seat support (9).
2. Position the operator seat (2) onto the seat support (9) and secure with the 4
socket head screws (5), washers (10) and nuts (11).
3. Connect the seat electrical connector to the machine wire harness
149).
4. Connect the battery negative cable from the battery; refer to Operator's
Manual.
Figure 149
3. Seat switch connector
IMPORTANT
IMPORTANT
Page 7–17
(Figure
Chassis: Service and Repairs