Table Of Contents - Ultra Start 430 Series Install Manual
Hide thumbs
Also See for 430 Series:
- Install manual (13 pages) ,
- Owner's manual (8 pages) ,
- Owner's manual (4 pages)
Table of Contents
Advertisement
REMOTE VEHICLE SECURITY
Programming
To Enter Program Mode
1) Make sure ignition is in the off position.
2) Within three seconds turn the key ON the OFF.
3) Press and release the Program Button two times.
4) The siren will chirp and the lights will flash once to confirm.
NOTE: If unit does not enter Program Mode, repeat steps 2-3.
** The ignition input wire(yellow on the 10 pin connector) MUST be connected.
If it is not connected it will not be possible to enter the Program Mode.
Changing A Programmable Setting
1) Enter Program Mode As explained above.
2) When in program Mode, change the desired Program Setting by pressing
the transmitter buttons in the following sequences.
NOTE: The Systems Default Setting Are Shown In Bold Lettering.
Quick View Programming
Programmable Feature
Door Input / Voltage Sense
Siren/ Horn Output**
*CJ series ONLY
**441 series ONLY
#1
#1
#2
#2
#3
#3
Press Buttons
#3-#3-#1
#2-#1-#1
#1-#3-#2
#1-#3-#1
#2-#2-#1
#1-#1-#3
#3-#3-#2
#1-#2-#3
#2-#1-#3
#3-#2-#1
#3-#3-#3
INSTALL MANUAL
#1
#1 #2
#2
#3
#3
One Chirp
Disabled
Chirps Off
Off
3 Second
Two Pulses
Voltage
Active
Active
Deactivated
Siren
Confirmed by Three Siren Chirps
PAGE 7
Two Chirps
Enabled
Chirps On
On
.75 Second
Single Pulses
Door Pin
Passive
Passive
Activated
Horn
Advertisement
Table of Contents
