U-Line Wine Captain 1115WC Use And Care Manual page 17

7. Relocate plastic spacer/bushing (Figure 22) on bottom
of door to opposite side, and place door on bottom
hinge pin. Clean out bushing hole in door bottom with
a screwdriver if necessary.
Plastic
Plug Hole
Right Side
Door Swing
Right Side
Hinge
Figure 23
8. Remove plastic hole plug (Figure 23) from door handle
and relocate on opposite side.
9. Remove pivot screw from top hinge, invert screw and
reinstall pivot screw in top hinge. See Figure 26.
Figure 24
10. Remove three plastic screw plugs (Figure 24) from
hinge holes, top of cabinet, opposite side. Be careful
not to scratch cabinet.
11. Place door on lower hinge pin. Invert and install upper
hinge on door.
Figure 25
Hinge
Plastic
Plug Hole
Screw
Left Side
Door Swing
Invert Invert
Screw Hinge
ULIN_0142_A
ULIN_0144_A
ULIN_0145_A
1115WC, 1175WC
12. Fasten upper hinge to unit (three screws) (Figure 25).
Partially tighten screws.
13. Adjust door to assure proper seal. Tighten upper and
lower hinge screws securely.
14. Replace three plastic plugs removed in Step 10 into
holes on top of unit. Replace screws in holes in bottom
of unit on opposite side.
15. Replace the grille and grille cap. Be sure to place grille
cap on opposite side of unit from where it was
originally.
Model 1175WC
To reverse the door, perform the following:
1. Remove the grille (two screws).
Figure 26
2. Remove top hinge from cabinet (four screws) (Figure
26). Hold door to keep it from falling.
3. Lift the door off the bottom hinge.
Figure 27
4. Remove four plastic plugs (Figure 27) in hinge holes,
top of cabinet, opposite side. Be careful not to scratch
cabinet.
ULIN
ULIN_0105_A
17