Honda XL650V Owner's Manual page 102

03/06/03 12:59:59 32MCB600_102
Installation:
1. Reverse the removal procedure.
Insert the axle through the left fork leg
and wheel hub.
2. Make sure that leg lug ( ) on the
speedometer gearbox is located behind
the lug ( ) on the right front fork ( ) leg. 8
3. Install the axle holder with the UP mark
( ) upward and approach the upper 10
holder nuts first, then the lower holder
nuts.
4. Tighten the front axle shaft to the
specified torque.
Front axle shaft torque :
64 N·m (6.5 kgf·m , 47 lbf·ft)
5. Tighten the axle holder nut to the
specified torque :
12 N·m (1.2 kgf·m , 9 lbf·ft)
Install the brake caliper and tighten to the
specified torque:
33 N·m (3.4 kgf·m , 25 lbf·ft)
6. After installing the wheel, apply the brake
several times and then check if the wheel
rotate freely. Recheck the wheel if the
brake drags or if the wheel does not
rotate freely.
92
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
Improper assembly may lead to loss of
7 braking capacity.
9
(10)
(9)
(7) Leg lug
(8) Lug
(8)
(7)
(9) Right front fork
(10) UP mark