Honeywell NOTIFIER ID2000 Series Installation & Commissioning Manual page 61

997-433-000-5, Issue 5
May 2010
ID2000 Series Installation & Commissioning Manual
Displays and Indications:
Alphanumeric display:
LED Status Indicators:
Zone Indicators:
Controls:
Dedicated flush push-buttons are provided for the following functions:
Additional pushbuttons for programming and selection of software
functions:
System Capacity:
Number of loops:
Number of zones:
Devices per loop:
External Connections:
Cable entry:
Terminals:
Electrical:
Classification:
Supply Rating:
Mains supply to the panel is to be provided via an external double-
pole mains isolation unit. The supply rating is:
230V~(ac) ± 15%, 5A, 50Hz ± 4%
Fuse Rating (of terminal block):
T 5A 250V H Ceramic
A2 - 2
2-line x 40-character back-lit LCD
DISABLEMENT, TEST, EARTH
FAULT, POWER SUPPLY FAULT,
SYSTEM FAULT, POWER, PRE-
ALARM, SOUNDERS DISABLED,
SOUNDER FAULT, DELAY ACTIVE,
DAY MODE.
Individual FIRE and Fault indicators
for 16 or 80 zones (depending upon
configuration options).
MUTE BUZZER
ACCEPT
EVACUATE
SILENCE SOUNDERS
RESOUND SOUNDERS
RESET
10-KEY NUMERIC KEY-PAD
KEYS
AND KEYS
KEY
Up to 8 depending
configuration options.
16 or 80 depending
configuration options.
99 sensors + 99 modules or
99 sensors + combination of up to
99 modules/sounders within strict
limits.
25 x 20mm knock-outs in top of
cabinet, 15 in rear, 4 in bottom.
All external connections made
through screw terminals, each of
which will accept cable sizes
between 0.5 mm and 2.5 mm
2
Installation Class I, (panel must be
earthed)
upon
upon
.
2