Back Box Fixing - Honeywell NOTIFIER ID2000 Series Installation & Commissioning Manual

ID2000 Series Installation & Commissioning Manual
Drawing showing
large ID2000 back
box fixing details
Notes:
All dimensions are in millimetres.
Fixing hole diameters are 6mm.

2.4.3 Back Box Fixing

The ID2000 Series control panel back boxes are available
122mm deep and 220mm (external dimensions including
fixing dimples). Where required, the deeper back boxes
allow the fitting of high-capacity-rated batteries as defined
in Section 7.5 Batteries and internally-mounted PSUs other
than the 3A-rated version. Where two part numbers are
quoted in the drawing at left, the first number refers to the
shallower back box and the second number refers to the
deeper back box.
The standard back box (PN: 020-472-XXX) is available
only in the 122 mm depth.
The fixing dimensions given below are applicable
irrespective of the back box depth.
Back Box Extension
In addition to the main back boxes, a smaller version, known
as a back box extension, is available. The back box
extension is also available in two depths: standard and deep.
The back box extension is designed to be wall mounted
immediately below any of the range of similar depth main
back boxes and is provided with corresponding 20mm
knockouts on the top and bottom faces. 20mm knockouts
are also provided on the top, bottom and rear faces of the
back box extension.
Wall Flatness
To prevent distortion, the ID2000 Series back box MUST
be installed on the wall as flat as possible, i.e. with a
maximum flatness deviation between any two points of
3mm. Where the wall is out of tolerance, use appropriate
packing pieces when installing the back box to meet the
above requirements.
Failure to comply with this requirement will result in
the misalignment of the internal and external screw
fixings.
Procedure
When a suitable location has been found for installing the
ID2000 Series control panel, proceed as follows:
1 Using the centrally-positioned keyhole to temporarily
hold the back box in the required position on the wall,
mark the position of the fixing holes while ensuring
the panel is level.
9
Continued overleaf..... Continued overleaf.....
997-433-000-5, Issue 5
May 2010