Mounting The Topdresser - Toro Workman Topdresser 1800 Operator's Manual

2

Mounting the Topdresser

Parts needed for this procedure:
2 Attachment bracket
2 Clevis pin
4 Lynch pin
4 Cap screw (1/2 x 1 inch)
8 Flat washer
4 Locknut (1/2 inch)
2 Spacer mount
Procedure
Lift equipment capacity: 370 kg (816 lb)
1. Remove the 2 flange-head cap screws and
flange locknuts securing rear of each engine
frame mounting bracket to the side of each
frame of the Workman vehicle
Note:
If the Workman vehicle is equipped with
a H.D. Hitch Frame, the attachment mount
brackets (steps 1
proceed to step 3.
1. Engine frame mounting
bracket
2. Frame (Workman vehicle)
2. Loosely secure a attachment bracket to each
engine frame mounting bracket and frame of the
Workman vehicle with 2 flange-head cap screws
and flange locknuts that you removed in step
1 (Figure 5).
Note:
If the Workman vehicle is equipped with
a H.D. Hitch Frame, install the spacer mounts,
steps 3 and 4, otherwise proceed to step 6.
(Figure 5).
and 2) are factory installed,
Figure 5
3. Attachment bracket
3. Remove the cap screw, 2 flat washers, and
locknut securing each attachment bracket to
hitch frame tabs
1. Hitch frame tab
2. Frame (Workman vehicle)
4. Secure a spacer mount to top of each hitch
frame tab with the cap screw, 2 flat washers,
and locknut previously removed
1. Spacer mount
g011382
5. Lift the machine as follows:
•
If you are using a forklift to lift the topdresser,
insert the forks through the lift tubes
8) at the rear flap.
8
(Figure 6).
Figure 6
3. Attachment frame
(Figure
Figure 7
g011391
7).
g011383
(Figure