Removing The 2/3 Or Full Bed - Toro Workman Topdresser 1800 Operator's Manual

1
Removing the 2/3 or Full
Bed
No Parts Required
Procedure
Lift equipment capacity: 150 kg (330 lb)
Note:
If the Workman vehicle is equipped with a H.D.
Hitch Frame, you do not need to remove it from the
vehicle but you must subtract the weight of the hitch
frame from the payload capacity of the hopper; refer
to the Workman Operator's manual.
1. Park the Workman vehicle on a level surface
and engage the parking brake.
2. Start the engine and move the hydraulic lift lever
to lower the bed until the cylinders are loose in
the bed slots.
3. Release the lift lever, shut off the engine, remove
the key, and wait for all moving parts to stop
before leaving the operator's position.
4. Remove the lynch pins from the outer ends of
the cylinder rod-clevis pins
1. Cylinder rod end
2. Bed mounting plate
3. Clevis pin
5. Remove the clevis pins securing the cylinder rod
ends to the bed mounting plates by pushing the
pins toward the inside
(Figure 3).
Figure 3
4. Lynch pin
5. Rear slots (Full bed)
6. Front slots (2/3 bed)
(Figure 4).
6. Remove the lynch pins and clevis pins securing
the pivot brackets to the frame channels
4).
1. Left rear corner of bed
2. Frame channel (Workman
vehicle)
3. Pivot plate
7. Lift the bed off of the Workman vehicle.
Important:
approximately 148 kg (325 lb), so do
not try to install or remove it by yourself.
Use an overhead hoist or get the help of 2
or 3 other people.
8. Store the cylinders in the storage clips.
9. Engage the hydraulic lift lock lever on the
Workman vehicle.
Important:
lock lever prevents you from accidentally
extending of the lift cylinders.
g002368
7
Figure 4
4. Clevis pin
5. Lynch pin
The full bed weighs
Engaging the hydraulic lift
(Figure
g002369