Product Overview; Controls - Toro Workman Topdresser 1800 Operator's Manual

quick-coupler fittings, connect the hoses to the
quick-coupler panel, and repeat steps
Figure 19
4. Visually inspect the hydraulic system for leaks,
loose fasteners, missing parts, and improperly
routed lines.
Make all repairs before operating the machine.
Important:
Ensure that the hoses are
routed away from any moving, sharp, or hot
components.
5. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operator's position.
6. Check the hydraulic fluid level; refer to the
Operator's Manual for your machine.
Add hydraulic fluid as needed.

Product Overview

2 and 3.

Controls

Gate Metering Control
The black knobs on the left rear side of the machine
are used to adjust and lock the gate into the desired
open height position.
1. Loosen the locking knob
allow it to slide freely in the slot.
g011387
2. Set the gate knob
position and tighten the locking knob to secure
the adjustment.
Rate Scale
Use the rate scale
flow rate. Refer to
1. Gate adjusting knob
2. Gate locking knob
13
(Figure 20) enough to
(Figure 20) into the desired
(Figure 20) to determine the desired
Sand Application Rate (page
Figure 20
3. Rate scale
18).
g266287