Installation And Wire Connection - Clarion FZ104PAE Owner's Manual & Installation Manual

INSTALLATION AND WIRE
CONNECTION
1. Before Starting
1. This set is exclusively for use in vehicles with a
negative ground 12 V power supply.
2. Read these instructions carefully.
3. Be sure to disconnect the battery "–" terminal
before starting. This is to prevent short circuits
during installation. (Figure 1)
2. General Cautions
1. Do not open the case. There are no user serviceable parts inside. If you drop anything into the unit
during installation, consult your dealer or an authorized
2. Use a soft, dry cloth to clean the case. Never use a rough cloth, thinner, benzine, or alcohol etc.
For tough dirt, apply a little cold or warm water to a soft cloth and wipe off the dirt gently.
3. Cautions on Installation
1. Prepare all articles necessary for installing the
source unit before starting.
2. If you have to do any work on the car body,
such as drilling holes, consult your car dealer
beforehand.
3. Use the enclosed screws for installation. Using
other screws can cause damage. (Figure 2)
4. Installation the Source Unit
1. Place the mounting bracket into the instrument
panel, use a screwdriver to bend each
stopper of the mounting bracket inward, then
secure the stopper.
2. Wire as shown in Section 7).
3. Insert the source unit into the mounting bracket
until it locks.
4. Take care of the top and bottom of the trim ring
and mount it so that all the hooks are locked.
Note: 1. Some car models require special mounting
kits for proper installation. Consult your
Clarion dealer for details.
2. Fasten the front stopper securely to
prevent the source unit from coming loose.
Clarion
service center.
Chassis
Max. 6 mm (M5 screw)
•
Console opening dimensions
7-3/16"
(182 mm)
Hole
Battery
Figure 1
Chassis
Damage
Figure 2
FZ104PAE
10