Stihl FS 410 C-M Instruction Manual page 30

English
At temperatures above +20°C
2
Always return the shutter (2) to the
N
summer position.
NOTICE
Do not operate the machine in the winter
position at temperatures above +20°C
because there is otherwise a risk of
engine running problems and
overheating.
At temperatures below -10°C
In extreme wintry conditions
temperatures below -10°C
–
powder or drifting snow
–
it is advisable to use the optional "cover
plate kit".
28
FS 410, 460
5
FS 490
5
The cover plate kit contains the following
parts for converting the power tool:
4 Cover plate partially blanks off the
slots in the starter housing
5 Air filter with synthetic fabric
element
For FS 460 with tank cap with
–
hinged grip: O-ring for the tank filler
cap
Instruction sheet describing the
–
conversion.
After installing the cover plate kit:
Set the shutter (2) to the winter
N
position.
At temperatures above -10°C
Remove the parts of the cover plate
N
kit and refit the standard parts for
summer operation.
Note for FS 460 with tank cap with
hinged grip: The O-ring supplied with the
2
cover plate kit can be left on the
machine's filler cap.
Depending on the ambient temperature:
Set the shutter (2) to the summer or
N
winter position.
4
Clean the air filter.
2
Loosen filter cover mounting
N
screws.
Remove the filter cover.
N
Clean away loose dirt from around
N
4
the filter (5) and inside the filter
cover.
Knock the filter (5) out on the palm
N
of your hand or blow it clear with
compressed air from the inside
outwards.
In case of stubborn dirt or sticky filter
fabric:
Wash the filter in a clean, non-
N
flammable solution (e.g. warm
soapy water) and then dry.
Always replace a damaged filter.
FS 410 C-M K, FS 460 C-M K, FS 490 C-M K