SATO Argox CP-EX Series User Manual page 37

CP-EX / CX Series
User Manual
LED Indicators: Power and Ready LEDs blink alternately
Power LED Ready LED
ON OFF
OFF ON
Possible Problems
Ribbon out
LED Indicators: Only the Power LED blinks
Power LED Ready LED
ON ON
OFF ON
Possible Problems
Serial IO error
Cutter has failed, or
there is paper jam
inside the cutter.
Other possible
hardware errors.
Compact Printer Series - User's Manual
Solutions
Install a new
ribbon roll
Solutions
Check serial baud rate at
both of your system and
the printer.
Check the cutter or
recover paper jam.
Contact the reseller for
further service.
33
Remarks
Set "Direct Thermal"
printing by driver or
commands if no ribbon is
required.
Remarks
For serial
interface only
Only applicable
when cutter
mode to cutter
mode.