Table of Contents
Advertisement
Clearing snow
For efficient operation, it is important to select an adequate engine
speed for the required snow discharge distance and clear the snow
without lowering the engine speed. If the engine speed keeps dropping
by setting the main shift lever in the LOW position, clear the snow as
follows.
• Clearing in narrow width
When the snow is deep or hard, set the main shift lever in slow and
clear the snow using a narrower clearing width (less than the width of
the snow blowing mechanism).
• Clearing with back and forth motions
If the snow is so hard that the snow thrower tends to ride over the
surface, push it back and forth to remove snow gradually.
NOTE:
When the ICS switch (HSM1380i) is in ON/the mode selector switch
(HSM1390i) is in AUTO or POWER, the auger housing automatically
rises while going in reverse.
In case the auger clutch switch is in the ON position, the auger is
automatically returned to the original position when the snow thrower
is transporting forward again (ETDR type).
74
Advertisement
Table of Contents
