SATO SG112-ex Driver Manual page 26

6. Configure the port settings and click [OK].
If you selected [TCP/IP (LAN)]
Note:
 You cannot set the same name as an existing port name.
 The computer cannot communicate with the destination product if the [Product Name or IP Address] and
[Port Number] settings do not match those of the product.
 Click [OK] to check communications using the configured settings. If communications failed, the following
screen appears.
[Cancel]
Returns to the previous screen. Click this button to change [Printer Name or IP Address] or any
other settings.
[Try Again]
Checks communications again.
[Continue]
Does not check communications and proceeds to the next step. Click this button when you want
to continue with the port setup without checking communications with the product.
 Normally, you do not need to change [Port Number] (the default value on the product is also 9100).
 Normally, you do not need to change the timeout settings.
 The [Advanced TCP/IP Port Configuration] dialog box can be displayed even after installing the printer
driver with the following procedure:
a. Open [Devices and Printers], right-click the desired product, and select [Printer properties].
b. Click the [Ports] tab.
c. Click [Configure Port].
26