Table of Contents
Advertisement
6. While holding the thread, pass it between the
tension discs and pull the thread down to make
sure that it is properly located in between the
tension discs. (Fig. 6)
7. Thread the looper area of the machine following
the orange coded thread guides (4 to 7). (Fig. 7)
8. Thread the hole in the upper looper from front to
back (8). (Fig. 7)
☞
Note: Use the tweezers provided in the accessory set
to help in threading the looper.
9. Pull about 4 inches (10 cm) of thread through the
looper and place to the back of the needle plate.
☞
Note: If the upper looper thread breaks during sewing,
this may be caused by the lower looper thread
getting caught on the upper looper. If this
happens, lower the upper looper by turning the
hand wheel, remove the lower looper thread from
the upper looper, and re-thread the upper looper
from at least the tension disc position.
Threading the lower looper (yellow)
1. Open the front cover by sliding to the right and
guiding the cover towards you.
2. Raise the telescoping thread guide to its highest
position.
3. Thread the lower looper thread (yellow) after
having threaded the upper looper.
Follow the numbered path in figure 8 from 1 to 8.
4. Pass the thread from the back to the front through
the thread guide. (Fig. 9)
5. Thread the top cover thread guide pulling the
thread downward until it slips under the thread
guide. (Fig. 10)
2
3
8
8
7
7
4
6
6
5
Fig. 8
Fig. 6
Fig. 7
1
Fig. 9
Fig. 10
14
Hide quick links:
Advertisement
Table of Contents
