Mode; Private Certificate - ATEN CN9600 User Manual

CN9600 User Manual
4. Custom: Click to check the following security options you wish to apply:
 Enable ICMP service
 Enable Telnet service
 Enable SSH session
 Enable HTTP session
 Enable HTTPS session (Select between "TLS 1.2", "TLS 1.0, 1.1, 1.2".)

Mode

Use this section to set the working mode parameters.
 Enable FIPS for FIPS security standard. The default is Disabled.
 Enable Multiuser Operation to permit more than one user to log into the
CN9600 at the same time. The default is Enabled.
 Enable Virtual Media Write allows redirected virtual media devices on a
user's system to send data to a remote server, as well as being able to have
data from the remote server written to them. The default is Enabled.
 If Disable Authentication is checked, no authentication procedures are
used to check users attempting to log in. Users gain Administrator access
to the CN9600 switch simply by entering combination of username and
password. The default is Disabled.
Note: Enabling this setting creates an extremely dangerous result as far as
security goes, and should only be used under very special
circumstances.

Private Certificate

When logging in over a secure (SSL) connection, a signed certificate is used to
verify that the user is logging in to the intended site. For enhanced security, the
Private Certificate section allows you to use your own private encryption key
and signed certificate, rather than the default ATEN certificate.
46