Gigabyte AORUS MASTER Z490 User Manual page 83

B-2: Installation in Intel RST Premium With Intel Optane System Acceleration mode
If the SATA controller has been configured in Intel RST Premium With Intel Optane System Acceleration mode,
please follow the steps below:
Step 1:
After system restarts, go to the BIOS Setup, make sure CSM
Support under the Boot menu is disabled.
Step 3:
Enter the operating system, launch the Intel
Technology utility from the Start menu, and then enable
Intel Optane Memory on the Intel
® ™
• An Optane memory cannot be used to accelerate an M.2 PCIe SSD.
™
• If more than one Optane
based boot drive. The other(s) can only be used as data drive(s).
• Do not abruptly remove the Optane
correctly.
• If you want to change/remove the Optane
Technology or Intel(R) Optane Memory application first.
• After enabling the Optane
Step 2:
Go to Settings\IO Ports\SATA And RST Configuration
and make sure USE RST Legacy OROM is disabled and
RST Control PCIe Storage Devices is set to Manual. If
you want to enable the Optane
M2P_SB connector, set PCIe Storage Dev On Port 21 to
RST Controlled; to enable the Optane
the M2A_CPU connector, set PCIe Storage Dev On Port 9
to RST Controlled; to enable the Optane
in the M2M_SB connector, set PCIe Storage Dev On Port
17 to RST Controlled.
Step 4:
Rapid Storage If you install more than one Optane
®
which one you are going to use. Then select which drive to
Optane Memory tab. be accelerated. Click Yes to continue. Follow the on-screen
® ™
instructions to proceed. When completed, restart the system.
Step 5:
Launch the Intel Rapid Storage Technology utility from the Start menu
®
and make sure the Intel
accelerate the system drive, you can select specific folders, files, or applications
to accelerate using the Intel
Optane memory used must have at least 32 GB capacity.)
™
memory is installed, you can select only one of them to accelerate your SATA-
™
memory. Doing so will cause the operating system to stop functioning
™
memory, you must disable it using the Intel
™
memory, the related BIOS settings will remain even after a BIOS update.
™
- 83 -
memory installed in the
™
memory installed in
™
™
memory, please select
™
Optane Memory has been enabled. If you want to
® ™
Optane Memory Pinning function. (The
® ™
Configuring a RAID Set
memory installed
Rapid Storage
®