Installing The 8335-Gtw Or 8335-Gtx System By Using Fixed Rails - IBM Power System AC922 Installing

Figure 1. Removing the filler panels
4. Facing the front of the rack and working from the right side, use tape, a marker, or pencil to mark the
lower hole of each EIA unit.
Mark the rack such that the mark can also be seen from the rear of the rack.
5. Mark the corresponding hole on the left side of the rack.
6. Go to the rear of the rack.
7. On the right side, find the EIA unit that corresponds to the bottom EIA unit marked on the front of the
rack.
8. Mark the bottom EIA unit.
9. Mark the corresponding hole on the left side of the rack.

Installing the 8335-GTW or 8335-GTX system by using fixed rails

If you ordered the system with the fixed rail option, use these procedures to install the system into the
rack by using fixed rails.
Installing and configuring the 8335-GTX 3