IBM Power Systems 7953-94X Installing page 25

Bolts
Stabilizer bracket
Figure 10. Bolting the front stabilizer to the floor surface
Bolt the rear of the rack to the floor surface through the holes in the lower frame by using two
bolts and washers.
Rack rear
Figure 11. Bolting the rear of the rack to the floor surface
v If a front stabilizer bracket or stabilizer plate is not installed, bolt the front of the rack to the
floor surface through the holes in the lower frame by using two bolts and washers.
Bolts
Installing the 7953-94X and 7965-94Y rack and features
11