IBM Power Systems 7953-94X Installing page 24

b. Position the front stabilizer bracket in front of the recirculation prevention plate and align the
screw holes.
c. Use the four screws and the hex wrench that come in the hardware kit to secure the front
stabilizer bracket and recirculation prevention plate to the rack cabinet.
d. Tighten the screws until the stabilizer bracket is flush against the recirculation prevention plate (if
it is used) or flush against the rack (if the recirculation prevention plate is not used).
6. For stand-alone rack cabinet 7953-94X and 7953-94Y:
If you are not installing the recirculation prevention plate, attach the front stabilizer to the front of the
rack cabinet with the screws and hex wrench that come with the hardware kit.
Stabilizer bracket
Figure 9. Installing the front stabilizer and no recirculation prevention plate
Note: If required by local building codes, each standalone rack can be bolted to the floor with a
fastener in each corner.
7. Bolt the rack to the floor surface by using the following methods:
v If a front stabilizer bracket or stabilizer plate is installed, bolt the rack to the floor surface
through the holes in the front stabilizer by using two bolts and washers.
10
Installing the 7953-94X and 7965-94Y rack and features