Garmin G3X TOUCH SYSTEM Flight Manual Supplement page 52

Climb:
After the autopilot is engaged it can be used e.g. for automatic controlled
climb. To set the requested parameters perform as follows:
Altimeter setting: Set the correct barometric setting using the
•
correlated knob.
Autopilot vertical mode setting:
•
touch VS (refer to: 4.1.5.3 Vertical Mode), Increase reference
vertical speed using the nose up/ nose down button
Power and trim setting:
•
accordance with the announcement of the autopilot.
All announcements displayed on the PFD-screen must be accomplished
promptly; otherwise the aircraft may attain flight situations, where the
pilot must immediately take over manually.
Cross-check attitude, altitude and speed regularly using primary flight
instruments!
Descent:
After the autopilot is engaged it can be used e.g. for automatic controlled
descend. To set the requested parameters perform as follows:
Altimeter setting:
•
AP vertical mode setting: Touch autopilot status box, then touch VS
•
Power and trim setting:
•
DOCUMENT NUMBER
L400-912816 ISSUEFEBRUARY 21 2020
FLIGHT MANUAL STEMME S12
Touch autopilot status box, then
Set power and trim as required in
WARNING
CAUTION
Set the correct barometric setting using
the correlated knob.
(refer to: 4.1.5.3
Decrease reference vertical speed using
the nose up/ nose down button
Set power and trim as required in
accordance with the announcement of
the autopilot.
Vertical Mode),
PAGE: 4-30
REVISION: --
DATE: --- --, -----