Cisco IE 3010 Installation Instructions Manual page 13

Switch Installation
Installing the Switch
Figure 19 Rack-Mounting
6
2
C i sco
I E 301 0
Sw i t ch Ser
i es
1 Mid-mounting position
2 Cable screw
3 Cable-side mounting position
After the switch is mounted in the rack:
1. Wire the switch to a power source. See
2. Connect the ports. See the
3. Attach the cable guide to prevent the cables from obscuring the LED panels on the devices in the rack. Use the
supplied black screw shown in
For configuration instructions about the CLI setup program, go to
page 81
1
C i sc o IE
30 10
4
C i sc o IE
3 30 10
4
5
4
4 Phillips machine screws
5 Power-supply-side mounting position
6 Cable guide
Power Supply Installation, page 47
Connecting Devices to the Ethernet Ports, page
Figure 19 on page 29
44.
to attach the cable guide to the left or right bracket.
Configuring the Switch with the CLI Setup Program,
29