Table of Contents
Advertisement
Handling Precautions
Be aware of the following precautions when handling this board:
- To prevent the board from being damaged, avoid shock and vibration
and do not bend the board.
- Do not modify the board. CONTEC is not responsible for modified
boards.
- Do not touch gold-plated terminals (edge connectors) on the board.
Touching the terminals causes poor contact. If you accidentally
touch a terminal, wipe it off with industrial alcohol.
- The board has switches which you need to set. Be sure to verify these
switches before mounting the board in the slot.
- Set the switches and jumpers on the board as designated. Setting
them otherwise will cause failures.
- Connect only designated signals to the connectors on the board.
Connecting otherwise will cause failures.
- Mount the board only in the designated expansion slot.
- Do not insert or remove the board with the PC or the I/O expansion
unit turned on. Inserting or removing the board with either power
turned on will cause failures. Be sure to turn the PC or the I/O
expansion unit off.
- The total current consumption of the board to be mounted in the
expansion slot of the PC or I/O expansion unit must not exceed the
power capacity allowed for the PC or the I/O expansion unit.
Exceeding the limit will cause failures.
BUF-PCI(PC), BUF-PCI(98)
Introduction
5
Advertisement
Table of Contents
