Installing For Windows Me - Contec BUF-PCI(PC) User Manual

Setup

Installing for Windows Me

Install the software for Windows Me following these steps.
(1) Install the BUS-PCI(PCI) board hardware.
(2) Install the BUF-PCI driver software.
(3) Run the BUF-PCI self-diagnostic program.
Installing the BUS-PCI(PCI) board hardware
Before the BUS-PCI(PCI) board can be used under Windows Me, the
OS must recognize the I/O addresses and interrupt level (IRQ) to be
used for the BUS-PCI(PCI) board. Use the appropriate procedure to
install the BUS-PCI(PCI) board.
In Windows Me, keep in mind that it takes about 5-10 minutes to detect
the hardware.
(1) Turn the personal computer ON to start up Windows Me.
(2) Windows Me will come up with the [New Hardware] detection
(3) The wizard will automatically detect the INF file on the floppy
(4) In the next dialog box, you will find a message of "Windows has
24
dialog box. After making sure that "PCI Multimedia Device" is
displayed, insert the floppy disk into the drive, select "Automatic
search for a better driver. (Recommended)," and press [Next>].
disk and complete the registration.
finished installing the new hardware device." Then you click
[Finish] to complete the installation of the board. After finishing
installing the board, confirm the assigned resources. The
"Checking resources" part of this section explains you how to do
it.
BUF-PCI(PC), BUF-PCI(98)