Chapter 3: Access Point 8120 installation
This section contains procedures for the installation of the Access Point 8120.
Mounting a wireless LAN access point on a wall
The mounting bracket is designed to use wall anchors with threaded section diameters ranging
between 3.5mm and 4.5mm. If wall anchors have threaded diameters greater than 3.5mm,
only the two mounting holes marked 'A' may be used. If wall anchors have threaded diameters
of less than 3.5mm, the holes marked 'A' and the holes marked 'B' may be used. All wall
anchors must have a head diameter of less than 10mm or the wall mounting bracket cannot
be installed over them.
Perform the following procedure to mount a wireless LAN access point on a wall:
1. Locate the appropriate position of the wall anchors. The wall anchors should be
2. Install the screws into the wall anchors but do not seat them fully, leave at least a
3. Slip the wall bracket over the heads of the screws and slide the bracket to the right as
Avaya WLAN 8100 Installation–AP 8120
95mm apart horizontally and 80mm apart vertically.
The wall bracket is designed to use a minimum of 2 anchors and a maximum of 4.
2mm gap between the screw head and the wall.
viewed facing the wall.
August 20, 2010
13