Detecto APEX-RI Owner's Manual page 24

(HOUR)
The display will show
press the key. Otherwise, press the
the key to save it and proceed to the next prompt.
This is the current hour setting of the real time clock. Allowable values are 0 to 23.
NOTE: The hour is entered in a 24-hour format. When entering the hour after noon
(12:00 PM), you must add 12 to time. For example, 3:00 PM would be entered as 15.
(MINUTE)
The display will show
press the key. Otherwise, press the
the key to save it and proceed to the next prompt.
This is the current minute setting of the real time clock. Allowable values are 0 to 59.
(SECONDS)
The display will show
press the key. Otherwise, press the
the key to save it and proceed to the next prompt.
This is the current seconds setting of the real time clock. Allowable values are 0 to 59.
NOTE: The following two parameters are not used with the apex-RI series. Press
the key to save the current setting and proceed to the next prompt.
(Sonar Height Calibration)
The display will show
current setting and proceed to the next prompt.
(SENSOR HEIGHT)
The display will show
setting and proceed to the next prompt.
(HOLD TIME)
This setting is used by the scale to hold a stable patient weight for a desired amount of time.
For example, if a value of 5 seconds is used, then when the scale locks onto a stable
patient weight, it will remain locked for 5 seconds before automatically releasing the weight.
The display will show
press the key. Otherwise, press the
the key to save it and proceed to the next prompt.
This setting controls the auto-locking feature. Allowable values for hold time are 0 to 20.
18 3300-0329-0M Rev C apex Portable Scale Owner's
SCALE SETUP, CONT.
and the current setting. If the value displayed is acceptable,
or keys to select a new value, and then press
and the current setting. If the value displayed is acceptable,
or keys to select a new value, and then press
and the current setting. If the value displayed is acceptable,
or keys to select a new value, and then press
and the current setting
and the current setting. Press the
and the current setting. If the value displayed is acceptable,
or keys to select a new value, and then press
. Press the key to save the
key to save the current