Start/Stop Switch - Husqvarna H130 Mark II Workshop Manual

8.1 Dismantling
1. Remove the cylinder cover.
2. Remove the air filter.
3. Use a screwdriver to eject the primer bulb (A) from
the air filter holder (B). See Figure 1.
4. Remove the screws (C). See Figure 2.
5. Remove the nuts (D). See Figure 2.
6. Carefully pull out the air filter holder (B). See Figure
2.
7. Detach the cable (E). See Figure 2.
8.2 Cleaning and inspection
Carefully clean and check all components. See Figure 3.
Parts must be replaced if cracked or if they show signs
of other defects. Always use original spare parts.
8.3 Assembly
1. If the start/stop switch has been replaced, fit the
new start/stop switch to the air filter holder. See
Figure 3.
2. Fit the cable (E). See call-out in Figure 2.
3. Carefully attach the air filter holder (B) to the
carburettor. Make sure the hoses that attaches to
the primer bulb are not pinched. See Figure 2.
4. Tighten the nuts (D) and the screws (C). See Figure
2.

8 Start/stop switch

A
Fig. 1
E
E
Fig. 2
Fig. 3
Start/stop switch
B
C
D
English - 17