Advertisement
3
WORK
Info
Even when there is no load on the battery, it discharges steadily.
The charging level and the method of charging are very important for the service life of the battery.
Rapid recharging with a high charging current shortens the battery's service life.
If the charging current, charging voltage, or charging time is exceeded, electrolyte escapes through the safety valves. This
reduces the battery capacity.
If the battery is depleted from starting the vehicle repeatedly, the battery must be charged immediately.
If the battery is left in a discharged state for an extended period, it will become over-discharged and sulfate, destroying the
battery.
The battery is maintenance-free. The acid level does not have to be checked.
3.7
Installing the battery
Preparatory work
–
Switch off all power consumers and switch off the engine.
–
Remove the passenger seat. (
–
Remove the seat. (
–
Disconnect the negative cable of the battery to avoid damage to the onboard elec-
tronics.
Main work
–
Connect the battery charger to the battery. Switch on the battery charger.
Battery charger (58429074000)
You can also use the battery charger to test rest potential and start potential of the
battery, and to test the alternator. With this device, you cannot overcharge the bat-
tery.
Info
Never remove lid
Charge the battery with a maximum of 10% of the capacity specified on
battery housing
–
Switch off the battery charger after charging and disconnect from the battery.
Guideline
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use
–
Position the negative cable and mount and tighten the screw.
–
Position the negative terminal cover.
M00729-10
Finishing work
–
Mount the seat. (
–
Mount the passenger seat. (
–
Set the clock. (
Main work
–
Position the battery in the battery holder.
Guideline
The battery terminals must be facing upward.
Alternative 1
(125 Duke)
Battery (FTZ-7)
Alternative 1
B00751-11
(200 Duke)
Battery (FTZ-9)
–
Attach rubber band
–
Position the positive cable
–
Position positive terminal cover
p. 5)
p. 5)
.
.
3 months
p. 5)
p. 5)
p. 9)
.
and mount and tighten the screw.
.
7
Advertisement
