Bosch CM8S Operating/Safety Instructions Manual page 29

2610051821.qxp_BM CM8S 9/19/18 2:55 PM Page 29
Preparing for Saw Operations
▶ Workpiece Support
▼ CLAMPS
cannot be used. Support workpiece with your
hand outside the "No Hands" zone. Do not try to
cut short pieces that cannot be clamped and
cause your hand to be in the "No Hands" zone.
with the saw Off by conducting a simulated cutting
cycle, and observe the projected path of the saw
blade. Keep hands at least six (6) inches away from
the projected path of the saw blade.
There may be extreme
compound cuts where clamp
Be aware of the path of the
saw blade. Make a dry run
FIG. 29
Clamp
Clamp
Foot
Workpiece
FIG. 30
Clamp
Auxiliary
Clamp Hole
29
Clamp
Knob