Advertisement
AUDIO LEVEL CONTROL
Figure A
When using the CHTO-01 with a radio that has a high audio pre-out voltage,
usually greater than 2 volts, the audio signal may become distorted.
To resolve this follow these steps:
1. Make sure the ignition is turned to the "off" position.
2. Disconnect both of the harnesses from the CHTO-01.
3. Remove the cove from the CHTO-01 by squeeezing the sides of the
cover to release the clips.
4. Locate the potentiometer on the circit board. See Figure A.
5. Taking a small flat headed screwdriver, turn the potentiometer counter-
clockwise to lower the input level going to the factory amplifier.
6. After making the adjustment, replace the cover and reconnect wire
harnesses.
CHTO-01
AUDIO LEVEL
4
Advertisement
