Intake Fan Access/Replacement; Intake Fan Check; Meat Probe Temperature Verification; Cabinet Temperature Verification - Masterbuilt MWS 130S Instructions Manual

2. Unplug from wall.
3. Remove pellets from hopper.
4. Remove four screws holding pellet hopper to auger
housing. Reference Fig. 1 on page 42.
page 42.
Tip:
feeding new element plug thru housing easier in future steps.
8. Untie string and discard.
screws.
11. Install pellet hopper on auger housing.
Installation is complete.
replacement.

MEAT PROBE TEMPERATURE VERIFICATION

Low Temperature Test:
2. Let meat probe rest in ice water for 5 minutes.
3. Turn on appliance.
4. Press and hold meat probe button to read meat probe temperature.
High Temperature Test:
2. Let meat probe rest in boiling water for 5 minutes.
3. Turn on appliance.
4. Press and hold meat probe button to read meat probe temperature.
2. Turn on appliance.
5. Read actual cabinet temperature displayed.
6. Press and hold meat probe button to read meat probe temperature reading.
44
INTAKE FAN ACCESS / REPLACEMENT

INTAKE FAN CHECK

CABINET TEMPERATURE VERIFICATION

Fig. 2 on