Firmware Upgrade Command - ATEN CS1822 User Manual

Firmware Upgrade
The Firmware Upgrade command allows you to enable the firmware upgrade
mode. The default setting is off.
Use the Formula - to set Parameters - to create a Command.
Formulas:
Command + Control+ [Enter]
Parameters:
Command
upgrade
Control
on
Enter
Enter

Firmware Upgrade Command

The available formula for the Firmware Upgrade command is as follows:
1. Command + Control + [Enter]
For example, to enable firmware upgrade mode, type the following:
upgrade on [Enter]
CS1822 / CS4824 RS-232 Commands
Description
Firmware Upgrade Command
Description
Enable firmware upgrade mode
Description
Enter and send out command
15