Smeg C7194N2P User Manual page 15

32
Problem
Water flows inside the refrig‐
erator.
Water flows on the floor.
Temperature cannot be set.
dEMo appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
If the advice does not lead to
the desired result, contact the
nearest Authorised Service
Centre.
Possible cause
Food products prevent the
water to flow into the wa‐
ter collector.
The water outlet is clog‐
ged.
The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
The "FastFreeze function"
or "Shopping function" is
switched on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The "FastFreeze function"
or "Shopping function" is
switched on.
There is no cold air circu‐
lation in the appliance.
Replacing the lamp
The appliance is equipped with a longlife
LED interior light.
Solution
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet
to the evaporative tray.
Switch off "FastFreeze func‐
tion" or "Shopping function"
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FastFreeze function" or
"Shopping function".
Keep the OK pressed for ap‐
proximately 10 seconds until a
long sound is heard and dis‐
play shuts off for a short time.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Add less food products at the
same time.
Open the door only if necessa‐
ry.
Refer to "FastFreeze function"
or "Shopping function".
Make sure that there is cold
air circulation in the appliance.